Nissan Sunny service from 1991 to 1997 of release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and exhaust system
7. System of start-up of the engine
8. Coupling
8.1. Specifications
8.2. Coupling adjustment
8.3. Coupling cable
8.4. Coupling pedal
8.5. Coupling
8.6. Mechanism of switching off of coupling
9. Transmissions
10. Semi-axes
11. Brakes
12. Suspension brackets and steering
13. Body
14. Electric equipment
 







8-5-sceplenie.html

8.5. Coupling

Removal

PERFORMANCE ORDER
1. Remove a check point (see subsection 9.1).
2. Designate the provision of coupling on a flywheel.
3. Gradually unscrew bolts in a cross order.
4. Remove coupling, having paid attention to the provision of a frictional disk.

Check


Prevention

It is recommended to change all coupling assembled with the vyzhimny bearing even if only separate details are subject to replacement.


PERFORMANCE ORDER
1. Carefully clear coupling, having wiped liquid on a spirit basis.
2. Check wear of frictional slips.
3. If the distance from a surface of a frictional slip to heads of rivets is less or equally than 0,3 mm, frictional slips replace.
4. Replacement of slips also is required in case of detection of traces of oil on them, signs of deformation, cracks of traces of a proskalzyvaniye.
5. Check a condition шлицов naves of a frictional disk, springs, integrity of rivets.
6. If on a frictional disk oil traces are found, before installation of a new disk find the reason and eliminate.
7. Check a condition of a press disk, check durability клепки, having shaken a disk.
8. If overheat traces (a bluish shade) are visible or the diafragmenny spring weakened, coupling replace.
9. Check a condition of shlifovanny surfaces of a press disk and a flywheel.
10. Minor defects прошлифуйте, at strong damages of a detail replace.
11. Check a condition of the vyzhimny bearing, at the slightest defects replace.

Installation

PERFORMANCE ORDER
1. Carefully clear flywheel and coupling surfaces.
2. Establish a frictional disk so that the nave was turned from a flywheel.
3. Holding a frictional disk, put a coupling basket assembled on adjusting pins, having combined the put labels.
4. Tighten bolts by hand.
5. Center a frictional disk.
6. The disk can be centered, rotating a prutok in a nave, resting against an opening of a flywheel or by means of a special opravka.
7. Evenly, in stages, tighten bolts of fastening of coupling with the set moment.
8. Grease shlitsa of a shaft of a check point and a fork axis with a thin layer of refractory greasing.
9. Establish a check point.


8.4. Coupling pedal

8.6. Mechanism of switching off of coupling