Nissan Sunny service from 1991 to 1997 of release in n-14 body.
1. Maintenance instruction
2. Maintenance
2.1. Specifications
2.2. Service through each 15000 km or 6 months
2.3. Service through each 30000 km or 12 months
2.3.1. Check and replacement of belts of a drive of auxiliary units
2.3.2. Replacement of the fuel filter
2.3.3. Replacement of spark plugs (and/m without Catholic converter)
2.3.4. Check of work of a zaslonka of a temperature regulator of the air filter
2.3.5. Check of system of decrease in toxicity of the fulfilled gases
2.3.6. Check of the sensor of exhaust gases
2.3.7. Replacement of brake liquid
2.3.8. Suspension bracket and steering check
2.3.9. Check of covers of semi-axes
2.3.10. Check of an exhaust system
2.3.11. Check of corners of installation of wheels
2.3.12. Shift of wheels
2.3.13. Check of blocks of back drum-type brakes
2.3.14. Check of a condition of seat belts
2.3.15. Greasing of door loops and locks
2.3.16. Car check in road conditions
2.4. Service through each 60000 km or 2 years
2.5. Service through each 60000 km or 12 months
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semi-axes
11. Brakes
12. Suspension brackets and steering
13. Body
14. Electric equipment
 







2-3-obsluzhivanie-cherez-kazhdye-30000-km-ili-12-mesyacev.html

2.3. Service through each 30000 km or 12 months

On engines of considered cars it is provided from one drive to three belts, depending on a complete set. Belts are intended for a drive of the following units:

  – on cars without the power steering or the conditioner one belt (a drive of the generator and the pump of cooling liquid) is provided;  
 – on cars with the power steering two belts (one for a generator drive, another – for the pump of the power steering and the pump of cooling liquid) are provided;
  – on cars with the power steering and the conditioner three belts (purpose of two belts same, as at cars with the power steering and one belt for a drive of the compressor of the conditioner) are provided.

PERFORMANCE ORDER
1. Put the car on the hand brake, lift a forward part of the car and establish on supports. Remove the right forward wheel.
2. Working under a forward part of the car, unscrew screws and remove a plastic guard under a wing to get access to a crankshaft pulley. For expansion of working space it is possible to remove also in addition an engine mudguard, having unscrewed screws.
3. Turn the crankshaft the face head dressed on a bolt of a pulley so that it was possible to examine belts (or a belt) on all length. Check existence on belts of cracks, traces of a podgoraniye or mechanical damages. Check also existence on a belt of glossy sites and stratifications. At detection of damages or wear tracks a belt replace.
4. If a belt condition satisfactory, check a belt tension one of described below ways (depending on type and an engine complete set).


2.2.11. Check and adjustment of a drive of coupling

2.3.1. Check and replacement of belts of a drive of auxiliary units