Nissan Sunny service from 1991 to 1997 of release in n-14 body.
1. Maintenance instruction
2. Maintenance
2.1. Specifications
2.2. Service through each 15000 km or 6 months
2.2.1. Replacement of oil and oil filter
2.2.2. Check of turns of idling and quality of a mix
2.2.3. Replacement of spark plugs on cars without converter
2.2.4. Check of level of liquid of a hydraulic actuator of brakes
2.2.5. Check of level of liquid in the power steering
2.2.6. Check of level of liquid in automatic transmission
2.2.7. Check of leaks and condition of hoses
2.2.8. Check of level of oil in a manual transmission
2.2.9. Check of a condition of blocks of lobbies and back brakes.
2.2.10. Check and adjustment of the hand brake
2.2.11. Check and adjustment of a drive of coupling
2.3. Service through each 30000 km or 12 months
2.4. Service through each 60000 km or 2 years
2.5. Service through each 60000 km or 12 months
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semi-axes
11. Brakes
12. Suspension brackets and steering
13. Body
14. Electric equipment


2.2. Service through each 15000 km or 6 months

Replacement of the oil filter, bottom view


If the order of maintenance was not observed a long time, described below check and adjustment it is necessary to carry out as required.

Timely replacement of oil and the filter are the most important preventive categories of maintenance which the owner can independently execute. In process of oil aging in the engine there is its razzhizheniye and pollution that conducts to premature wear of the engine.

Before replacement of oil prepare all necessary tools and materials. Oil is best of all for merging on the heated-up engine as hot oil quickly and completely is removed from the engine, entraining pollution. Work considerably becomes simpler if the car costs on a platform, a viewing hole, or is lifted on a jack and established on supports. At change of oil horizontal position of the car, irrespective of a way of lifting, or its such situation at which the drain stopper of the pallet is in the lowest point should be supported.

1. Unscrew a stopper of a maslozalivny mouth on a cover of a head of cylinders.
2. Unscrew a drain stopper approximately on 1/2 turns. Substitute under a stopper a vessel and completely turn out a stopper. Remove from a stopper a sealing ring.
3. Merge oil, gradually moving the pallet is closer to a drain opening.
4. Wipe absolutely a stopper and a sealing ring. Check a condition of a sealing ring, at detection of damages a ring replace. Wipe a pallet surface round a drain opening, dress a ring, turn and tighten a stopper with the set moment.
5. The oil filter is on the right side of the block of cylinders, in its back part. Access to the filter is provided from below.
6. Substitute under the filter a vessel.
7. Weaken a filter inhaling a special key, then unscrew the filter hands. Merge oil from the filter in a vessel.
8. Wipe absolutely a place of consolidation of the filter on the engine, having removed the oil and dirt remains. Examine the fulfilled filter, check existence of laying which could stick to the block of cylinders, remove laying.
9. Slightly grease laying of the new filter by fresh oil for the engine and wrap the filter. After laying contacted with a surface of the block of cylinders, slightly tighten the filter, and then tighten on 2/3 turns.
10. Clean from under the car a vessel with the merged oil and the tool, lower the car.
11. Fill in a half of the demanded volume of oil. Wait about 2 minutes that oil flew down in the pallet. Continue to fill in oil in the small portions, until then while level will not reach the bottom point on щупе. Finish level to the top mark on щупе, having added about 1,0 l of oil.
12. Start the engine and within two minutes watch emergence of leaks about the oil filter and a drain stopper. Keep in mind that the control lamp of emergency pressure of oil will go out in some seconds after engine start-up, i.e. through time necessary for filling of the oil filter and oil channels. While the lamp did not go out the engine should work only idling.
13. Stop the engine, two minutes later again check oil level, if necessary add.

2.1. Specifications

2.2.1. Replacement of oil and oil filter