Nissan Sunny service from 1991 to 1997 of release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semi-axes
11. Brakes
12. Suspension brackets and steering
12.1. Specifications
12.2. Bearings of naves of forward wheels
12.3. Rack of a forward suspension bracket
12.4. Bottom lever
12.5. Spherical support of the bottom lever
12.6. Stabilizer of cross-section stability of a forward suspension bracket
12.7. Bearings of back wheels
12.8. Details of a back suspension bracket
12.9. Wheel
12.10. Switch of ignition and lock of blocking of a steering column
12.11. Steering column
12.12. Steering mechanism
12.13. Covers of steering transfer
12.14. Hydraulic actuator
12.15. Pump of the hydraulic booster
12.16. Tips of steering draft
13. Body
14. Electric equipment
 







12-4-nizhnijj-rychag.html

12.4. Bottom lever

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and establish on supports.
2. Remove a wheel.
3. Unscrew a nut of fastening of draft of the stabilizer to the bottom lever of a suspension bracket.
4. Unscrew two bolts (are specified by shooters) fastenings of a collar of the lever to a suspension bracket cross-piece, remove a collar.
5. Release a nut (it is specified by an arrow) lever axes.
6. Rasshplintuyte also unscrew a nut of a spherical support of the lever.
7. Disconnect the lever from a rotary fist, выпрессовав a spherical support.
8. Unscrew a nut of an axis of the lever, remove a washer.
9. Displace the lever down and disconnect from draft of the stabilizer, remove the plug and a washer.
10. Remove the lever from an axis and get from under the car.

Check

PERFORMANCE ORDER
1. Check a condition of the lever and plugs, existence on these details of wear tracks, cracks and other damages.
2. Check люфт a spherical support, freedom of rotation of a spherical finger in the case. check a condition of a rubber cover.
3. The lever represents not folding design and is replaced assembled. Plugs and a spherical support are not subject to separate replacement.

Installation


Prevention

All fastenings of the lever are finally tightened after removal of the car from a jack.


PERFORMANCE ORDER
1. Dress the lever on an axis.
2. Attach draft of the stabilizer, previously having established a washer and the draft plug (the washer should be turned by the convex party to the plug).
3. Dress a washer and wrap a new nut, without tightening.
4. Attach a spherical support to a fist, wrap a nut, without tightening.
5. Establish a collar of the bottom lever, wrap bolts.
6. Establish on draft of the stabilizer the bottom plug and a washer (the washer should be turned by the convex party to the plug), wrap a new nut.
7. Establish a wheel and lower the car.
8. Release the hand brake, roll the car forward and back, shake a forward part.
9. Tighten all fastenings of the lever with the set moments, зашплинтуйте a support nut new the shplinty.
10. Upon termination of check corners of installation of wheels.


12.3. Rack of a forward suspension bracket

12.5. Spherical support of the bottom lever