Nissan Sunny service from 1991 to 1997 of release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semi-axes
11. Brakes
12. Suspension brackets and steering
12.1. Specifications
12.2. Bearings of naves of forward wheels
12.3. Rack of a forward suspension bracket
12.4. Bottom lever
12.5. Spherical support of the bottom lever
12.6. Stabilizer of cross-section stability of a forward suspension bracket
12.7. Bearings of back wheels
12.8. Details of a back suspension bracket
12.9. Wheel
12.10. Switch of ignition and lock of blocking of a steering column
12.11. Steering column
12.12. Steering mechanism
12.13. Covers of steering transfer
12.14. Hydraulic actuator
12.15. Pump of the hydraulic booster
12.16. Tips of steering draft
13. Body
14. Electric equipment


12.11. Steering column


The present description does not belong to the cars equipped with a safety cushion.


1. Disconnect the battery from weight.
2. Remove a wheel.
3. Remove switches with levers (cм. subsection 14.4).
4. Disconnect from the ignition switch the socket.
5. Remove the bottom panel from the driver.
6. Get and pull together a column sealant in a partition of a motor compartment.
7. Remove from a partition of a motor compartment a metal cover, having unscrewed three nuts (on a part of cars).
8. Dress a wheel and turn a shaft for access to a bolt of the kardanny hinge.
9. Unscrew a hinge bolt.
10. Unscrew two top bolts and two bottom nuts and remove a column.


1. Check existence of deformation of a shaft, integrity of safety dvukhkonusny connection, if necessary a column replace.
2. Check a condition of bearings and plugs, люфты a shaft and hinges.
3. At the slightest signs of wear and damages a column replace.
4. Measure length of a column from an end face to a hinge pin.
5. If the length does not correspond to norm, a column replace.


1. Put on a column a cover and a sealant, fix a sealant a collar (if it is provided).
2. Establish a column and enter into the kardanny hinge so that the collar bolt at a wraparound rested against dredging on a shaft on the shlitsevy termination of a shaft.
3. Tighten two top bolts and two bottom nuts with the set moment.
4. Tighten a bolt of the kardanny hinge.
5. Put on a cover and tighten three nuts (on a part of cars).
6. Put on a cover a cover and fix a collar.
7. Establish the bottom panel.
8. Attach the socket to the ignition switch.
9. Establish lever switches.
10. Establish a wheel.
11. Connect the battery to weight.

12.10. Switch of ignition and lock of blocking of a steering column

12.12. Steering mechanism