Nissan Sunny service from 1991 to 1997 of release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semi-axes
11. Brakes
11.1. Specifications
11.2. Hydraulic actuator of brakes
11.3. Tubes and hoses
11.4. Blocks
11.5. Brake disk
11.6. Drums
11.7. Support of a forward brake
11.8. Support of a back brake
11.9. Wheel cylinder
11.10. Main cylinder
11.11. Brake pedal
11.12. Vacuum amplifier of brakes
11.13. Amplifier of brakes and return valve
11.14. Lever of the hand brake
11.15. Cables of the hand brake
11.16. Adjustment of the hand brake
11.17. Switch of a signal of braking
11.18. Switch of a lamp of the hand brake
11.19. Anti-blocking system
12. Suspension brackets and steering
13. Body
14. Electric equipment
 







11-7-support-perednego-tormoza.html

11.7. Support of a forward brake

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and establish on supports.
2. Remove a wheel.
3. For decrease in losses of liquid densely wrap a stopper of a tank having laid a polyethylene film, or press hoses.
4. Clear the ring union of a hose and unscrew a bolt.
5. Remove two laying.
6. Remove blocks.
7. Unscrew the top finger of a support.
8. Remove a support.
9. If necessary it is possible to remove a support arm.

Dismantling

PERFORMANCE ORDER
1. Carefully clear a support.
2. Get fingers for heads of bolts which screw in fingers.
3. Remove rubber covers of fingers.
4. Remove a lock ring and a cylinder cover.
5. Take the piston, having submitted air from the pump to an union opening.
6. A wooden stick get a cylinder sealant.
7. Wash out all details in pure brake liquid or alcohol.
8. All a sealant and covers are subject to obligatory replacement.
9. Check a support condition, especially carefully examine the piston and an internal surface of the cylinder, worn-out details replace. The support or a support arm separately in the spare part are not delivered.
10. Minor defects on the cylinder are eliminated with polishing by a small skin whereas the piston with the same defects is subject to obligatory replacement. To polish the piston it is forbidden.
11. Check a condition of carvings on support fingers, люфт fingers in a support should be absent.
12. Blow channels in a support.
13. Before assembly check purity of all details.
14. Dip a cylinder sealant into liquid and establish in a cylinder flute.
15. Dress a cover edge in a cylinder flute, grease with brake liquid the piston and the cylinder, establish the piston in the cylinder and dress the second edge of a cover on the piston.
16. Dress new covers on support fingers, before installation in a support grease fingers with brake liquid.

Installation

PERFORMANCE ORDER
1. Establish a support arm, tighten bolts.
2. Establish a support, grease a carving of a bolt of the top finger with fixing structure and wrap a bolt with the set moment.
3. Establish blocks.
4. Check freedom of moving of a support in an arm.
5. Attach a hose, having established two laying and having tightened a bolt of the ring union.
6. Remove polyethylene laying from a tank stopper (or remove collars from hoses).
7. Remove air from a hydraulic actuator of a brake of a wheel (if integrity of other contours was not broken).
8. Press several times a brake pedal.
9. Establish a wheel, lower the car.


11.6. Drums

11.8. Support of a back brake