Nissan Sunny service from 1991 to 1997 of release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semi-axes
11. Brakes
11.1. Specifications
11.2. Hydraulic actuator of brakes
11.3. Tubes and hoses
11.4. Blocks
11.5. Brake disk
11.6. Drums
11.7. Support of a forward brake
11.8. Support of a back brake
11.9. Wheel cylinder
11.10. Main cylinder
11.11. Brake pedal
11.12. Vacuum amplifier of brakes
11.13. Amplifier of brakes and return valve
11.14. Lever of the hand brake
11.15. Cables of the hand brake
11.16. Adjustment of the hand brake
11.17. Switch of a signal of braking
11.18. Switch of a lamp of the hand brake
11.19. Anti-blocking system
12. Suspension brackets and steering
13. Body
14. Electric equipment
 







11-6-barabany.html

11.6. Drums

Removal

PERFORMANCE ORDER
1. Lift a back part of the car and establish on supports.
2. Remove a wheel.
3. Release the hand brake.
4. If the drum does not give in to removal, reduce blocks, having arrived as follows.
5. Get a cap from an opening in a brake board.
6. Insert a screw-driver into this opening, then pass a screw-driver through an opening in a block against the stop in the lever of the hand brake. Slightly strike on a screw-driver to release the regulator mechanism then reduce blocks.
7. If the removed drum is established, put adjusting labels.
8. Remove a drum from wheel hairpins.
9. If the drum nevertheless does not give in to removal, displace it, evenly wrapping bolts М8 in special carving openings.

Check


Prevention

Drums change only in pair and with a set of blocks.


PERFORMANCE ORDER
1. Carefully clear a drum of a dust and dirt.
2. Check existence on a drum of cracks and wear tracks (with special attention check places about openings under hairpins).
3. Check a condition of an internal surface, in the presence of traces of deep development the drum is subject to replacement.
4. If on an internal surface of a drum the fillet caused by wear was formed, the drum is subject to replacement. The fillet formed owing to corrosion or deposits of dirt should be removed a small skin.
5. Check ovality of a drum, having measured diameter in two mutually perpendicular directions. Ovality is corrected by a pro-point if after processing diameter of a drum does not become less limiting.

Installation

PERFORMANCE ORDER
1. From a new drum remove preservative.
2. Reduce length of a strut, having twisted a gear nut to establish a drum.
3. Establish a drum, having combined the put labels (if the removed drum is established).
4. Press several times a brake pedal.
5. Adjust the hand brake.
6. Establish a wheel, lower the car.
7. Before departure check work of brakes.


11.5. Brake disk

11.7. Support of a forward brake