Nissan Sunny service from 1991 to 1997 of release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semi-axes
11. Brakes
11.1. Specifications
11.2. Hydraulic actuator of brakes
11.3. Tubes and hoses
11.4. Blocks
11.5. Brake disk
11.6. Drums
11.7. Support of a forward brake
11.8. Support of a back brake
11.9. Wheel cylinder
11.10. Main cylinder
11.11. Brake pedal
11.12. Vacuum amplifier of brakes
11.13. Amplifier of brakes and return valve
11.14. Lever of the hand brake
11.15. Cables of the hand brake
11.16. Adjustment of the hand brake
11.17. Switch of a signal of braking
11.18. Switch of a lamp of the hand brake
11.19. Anti-blocking system
12. Suspension brackets and steering
13. Body
14. Electric equipment
 




sell track2


11-2-gidroprivod-tormozov.html

11.2. Hydraulic actuator of brakes

For effective work of brakes it is necessary to remove air from a hydraulic actuator.

At removal of air it is forbidden to add the fulfilled liquid.

PERFORMANCE ORDER
1. At hit of the liquids which are differing from recommended system it is necessary to wash out and replace everything a sealant.
2. Before removal of air it is necessary to eliminate any violation of tightness of a hydraulic actuator.
3. Establish the car on an equal surface, stop the engine and turn on the hand brake.
4. Remove caps and wipe absolutely everything the union.
5. Uncover a tank, add liquid to a mark the MOVE.
6. Leaky wrap a cover, considering that level of liquid should be supported always above MIN mark.
7. In the absence of a special set of work on removal of air it is necessary to carry out together.
8. When using a special set be guided by the instruction attached to a set.
9. Irrespective of a way it is necessary to observe sequence of pumping.
10. If the hydraulic actuator is depressurized partially, it is possible to be limited to air removal only from the depressurized contour.
11. Sequence of pumping of brakes: the back left, forward right, back right, forward left.
12. Prepare a transparent vessel and a hose.
13. Dress a hose on the union (at the left the arrow specified an union cap).
14. Other end of a hose place in a vessel, having poured a little liquid.
15. Check liquid level in a tank.
16. Ask the assistant to press several times a pedal of a brake and to hold.
17. Unscrew the union on 1 turn. When liquid will cease to follow wrap the union and ask the assistant to release a pedal.
18. Check liquid level in a tank.
19. Repeat such cycle until then while air will not be removed from system to what lack of vials in the liquid following through a hose testifies. Between separate cycles maintain about 5 seconds.
20. Establish a dustproof cap, wrap the union, remove a hose and dress a cap.
21. Repeat procedure on other wheels.
22. Check liquid level in a tank.
23. Upon termination of pumping the pedal of a brake should be "rigid".
24. Otherwise repeat procedure.
25. If after pumping repetition the pedal remains "soft", the reason is wear of cuffs of cylinders.


11.1. Specifications

11.3. Tubes and hoses