Nissan Sunny service from 1991 to 1997 of release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semi-axes
11. Brakes
11.1. Specifications
11.2. Hydraulic actuator of brakes
11.3. Tubes and hoses
11.4. Blocks
11.5. Brake disk
11.6. Drums
11.7. Support of a forward brake
11.8. Support of a back brake
11.9. Wheel cylinder
11.10. Main cylinder
11.11. Brake pedal
11.12. Vacuum amplifier of brakes
11.13. Amplifier of brakes and return valve
11.14. Lever of the hand brake
11.15. Cables of the hand brake
11.16. Adjustment of the hand brake
11.17. Switch of a signal of braking
11.18. Switch of a lamp of the hand brake
11.19. Anti-blocking system
12. Suspension brackets and steering
13. Body
14. Electric equipment
 







11-15-trosy-ruchnogo-tormoza.html

11.15. Cables of the hand brake

CABLES OF BACK BRAKES

2 cables – left and right are provided.

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and establish on supports.
2. Release the hand brake.
3. On back drum-type brakes remove blocks and disconnect a cable from the lever, remove a spring and a cable arm (shooters specified nuts of an arm of a brake).
4. On back disk brakes get a bracket.
5. Disconnect a tip of a cable (shooter) from the support lever on back brakes.
6. Unscrew nuts and bolts of fastening of arms of a cover of a cable to the bottom.
7. Disconnect a cable from a leveling roller in a forward part of the car and remove a cable.
8. For access to a roller it is required to remove a thermal guard.

Installation

PERFORMANCE ORDER
1. The cable is established upside-down.
2. The ledge on an arm of a cable should come into dredging in a support
(disk brakes).
3. Adjust a cable.

CABLES OF FORWARD BRAKES

Removal

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Block back wheels and release the hand brake.
3. Remove the central section of the forward panel.
4. Disconnect the socket from the switch of a control lamp of the hand brake.
5. Count up quantity of strings of a carving to a nut, unscrew a nut and disconnect an adjusting bolt from the brake lever.
6. Lift a forward part of the car.
7. Disconnect back cables from a leveling roller in a forward part of the car and remove a cable.
8. Remove forward cables with the equalizer and an adjusting bolt, having passed through an opening in a floor.

Installation

PERFORMANCE ORDER
1. The cable is established upside-down.
2. Unscrew a nut on in advance counted up number of strings of a carving, check work of a brake and if necessary adjust.
3. Before installation of the panel check serviceability of the switch and a control lamp.


11.14. Lever of the hand brake

11.16. Adjustment of the hand brake