Nissan Sunny service from 1991 to 1997 of release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semi-axes
11. Brakes
11.1. Specifications
11.2. Hydraulic actuator of brakes
11.3. Tubes and hoses
11.4. Blocks
11.5. Brake disk
11.6. Drums
11.7. Support of a forward brake
11.8. Support of a back brake
11.9. Wheel cylinder
11.10. Main cylinder
11.11. Brake pedal
11.12. Vacuum amplifier of brakes
11.13. Amplifier of brakes and return valve
11.14. Lever of the hand brake
11.15. Cables of the hand brake
11.16. Adjustment of the hand brake
11.17. Switch of a signal of braking
11.18. Switch of a lamp of the hand brake
11.19. Anti-blocking system
12. Suspension brackets and steering
13. Body
14. Electric equipment
 







11-12-vakuumnyjj-usilitel-tormozov.html

11.12. Vacuum amplifier of brakes

Removal

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. On carburetor engines the amplifier it is possible to remove without removing soaking-up collector or the main cylinder.
3. On injector engines for access to the amplifier it is necessary to remove soaking-up collector.
4. On carburetor engines remove the air filter (cм. subsection 6.1.2).
5. Disconnect wires from the sensor of pressure of the hydraulic booster, remove an arm of a hose of the hydraulic booster.
6. Remove the main cylinder from the vacuum amplifier.
7. Disconnect from the vacuum amplifier a hose.
8. Disconnect a pusher from a pedal and unscrew four nuts of fastening of an arm to the amplifier.
9. Remove the amplifier from a motor compartment.

Prevention

Do not damage a carving of hairpins of the amplifier of brakes.


Installation

PERFORMANCE ORDER
1. The amplifier is established upside-down.
2. Before installation check a pusher vystupaniye over a surface of the case of the amplifier.
3. On cars without ABS system adjust the provision of a pusher of the main cylinder, having exposed the size A.
4. The collector and the main cylinder are established in compliance of c by subsection 6.2.14 and subsection 11.10.
5. Upon termination of adjust a brake pedal.


11.11. Brake pedal

11.13. Amplifier of brakes and return valve