Nissan Sunny service from 1991 to 1997 of release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semi-axes
11. Brakes
11.1. Specifications
11.2. Hydraulic actuator of brakes
11.3. Tubes and hoses
11.4. Blocks
11.5. Brake disk
11.6. Drums
11.7. Support of a forward brake
11.8. Support of a back brake
11.9. Wheel cylinder
11.10. Main cylinder
11.11. Brake pedal
11.12. Vacuum amplifier of brakes
11.13. Amplifier of brakes and return valve
11.14. Lever of the hand brake
11.15. Cables of the hand brake
11.16. Adjustment of the hand brake
11.17. Switch of a signal of braking
11.18. Switch of a lamp of the hand brake
11.19. Anti-blocking system
12. Suspension brackets and steering
13. Body
14. Electric equipment
 







11-11-pedal-tormoza.html

11.11. Brake pedal


Measurement of height of a pedal

1. Switch of a signal of braking

2. Rug

3. Waterproofing layer

4, 6. Antinoise covering of a partition

5. Floor

7. Rug

8. Pusher

9. Lock-nut

And. Free wheeling

D. Height of the pressed pedal

H. Height of the released pedal

Adjustment

PERFORMANCE ORDER
1. Measure distance from a pedal to a floor.
2. If necessary remove the bottom forward panel from the driver (cм. subsection 13.26).
3. Remove a slip in feet of the driver, disconnect latches and remove a rug, having opened access to the hatch in an antinoise covering of a floor.
4. Remove the hatch and check pedal height.
5. Compare to standard value.
6. If necessary adjust a pedal, having arrived as follows.
7. Unscrew a lock-nut of a pusher and rotating a pusher establish the necessary height of a pedal.
8. Tighten a lock-nut with the set moment.
9. Check a free wheeling of a pedal which is equal to pedal moving to feeling of weakness in resistance to its course.
10. After a pedal otpuskaniye the signal of braking should die away.
11. Otherwise replace the switch (the switch is strengthened on a pedal arm by bayonetny connection and it is not regulated).
12. Start the engine and idling check height of the pressed pedal.
13. If the height is less than norm, brakes are faulty.
14. In this case replace liquid in a hydraulic actuator and remove air.
15. If this measure does not give results, check a condition of the main thing and wheel cylinders.
16. Upon termination of establish all removed panels.

Removal

PERFORMANCE ORDER
1. Remove the bottom forward panel from the driver.
2. Rasshplintuyte also remove an axis, check an axis condition.
3. Disconnect wires from the switch of a signal of braking.
4. Unscrew four nuts of fastening of an arm of a pedal to a partition (the same nuts the vacuum amplifier fastens also).
5. Unscrew the top bolt and remove a pedal with an arm.
6. The pedal of a brake is executed together with an arm and separately does not change.

Installation

PERFORMANCE ORDER
1. The pedal is established upside-down.
2. Check pedal adjustment.


11.10. Main cylinder

11.12. Vacuum amplifier of brakes