Nissan Sunny service from 1991 to 1997 of release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semi-axes
10.1. Specifications
10.2. Semi-axis removal
10.3. Semi-axis installation
10.4. Repair of a semi-axis and replacement of protective covers
10.5. Check of CV JOINTS
10.6. Bearing of an intermediate support of the right semi-axis
11. Brakes
12. Suspension brackets and steering
13. Body
14. Electric equipment
 







10-3-ustanovka-poluosi.html

10.3. Semi-axis installation


Prevention

At assembly to obligatory replacement are subject: a semi-axis nut, a lock ring of the internal CV JOINT, all removed шплинты, nuts of the bottom spherical support.


Installation

PERFORMANCE ORDER
1. Check a condition of an epiploon of a semi-axis, it is recommended to replace an epiploon.
2. Carefully clear shlitsa of a semi-axis, grease shlitsa and an epiploon edge.
3. Check reliability of fastening of collars of covers.
4. Replace an internal lock ring (which was exposed to deformation at removal).
5. At installation of a semi-axis be careful, do not damage an epiploon.
6. At greasing of an epiploon and шлицов it is possible to establish a semi-axis, without using adaptations.
The right semi-axis on cars of early release (the intermediate support is absent)
7. Carefully, without having damaged an epiploon, enter a semi-axis into differential.
8. Enter shlitsa into gearing with shlitsa of a leading gear wheel, press a semi-axis so that the lock ring came into a flute of a leading gear wheel.
9. Be convinced that the ring came into a flute, with force having shaken a semi-axis.
The right semi-axis on cars with an intermediate support
10. Carefully, without having damaged an epiploon enter a semi-axis into differential, having passed through a window in an arm.
11. Combine openings under bolts and insert the bearing case.
12. Tighten bolts with the set moment.
The left semi-axis on all cars, except equipped with automatic transmission
13. Procedure same, as at installation of the right semi-axis.
The left semi-axis on cars with automatic transmission
14. Procedure same, as at installation of the right semi-axis. At first the right semi-axis is established left, then.
All cars
15. Grease external shlitsa of a semi-axis and insert into a nave.
16. Dress a washer and wrap a new nut.
17. Insert a spherical support into a pin and tighten a nut with the set moment.
18. Attach a tip of steering draft, tighten a nut.
19. Tighten a nut of steering draft so that it was possible to insert шплинт, without exceeding the set moment of an inhaling.
20. Zashplintuyte nut.
21. Establish a brake support.
22. Tighten a new nut of a semi-axis with the set moment, holding a nave from a provorachivaniye.
23. Establish a new koronchaty lock washer, having combined a groove under шплинт with an opening in a semi-axis, and зашплинтуйте.
24. Establish wheels, lower the car.
25. Fill in in a case oil / transmission liquid.


10.2. Semi-axis removal

10.4. Repair of a semi-axis and replacement of protective covers