Nissan Sunny service from 1991 to 1997 of release in n-14 body.
1. Maintenance instruction
1.1. Control panel
1.2. Alarm lamps
1.3. Arrangement of identification plates
1.4. Radio receiver AM-UKV with electronic control
1.4.1. Using radio receiver
1.4.2. Control for station
1.4.3. Control programming
1.4.4. ARI station reception (road information)
1.4.5. Timbre control
1.4.6. Balance control
1.5. An AM-VHF-radio tape recorder with electronic control
1.6. Catalyst
1.7. Keys
1.8. Ignition switch and ignition lock
1.9. Handle of management of a screen wiper and windscreen washer
1.10. The combined switch of a driving and passing beam
1.11. Heating of back glass and lateral mirrors
1.12. Possible malfunctions
2. Maintenance
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semi-axes
11. Brakes
12. Suspension brackets and steering
13. Body
14. Electric equipment
 







1-4-radiopriemnik-am-ukv-s-ehlektronnojj-nastrojjkojj.html

1.4. Radio receiver AM-UKV with electronic control

Radio receiver AM-UKV with electronic control

1. Button of automatic control
2. Regulirvka of a timbre
3. Handle of turning on of the receiver, regulator of loudness and balance of the left and right loudspeakers
4. Control with fall of frequency of reception
5. Control button
6. Control with increase of frequency of reception
7. Button of a choice of an AM mode or WC (VHF)
8. Button of a choice of a range
9. Display
10. Knpka of a stereo choice / the mono

PERFORMANCE ORDER
1. Turn on the receiver, having turned the PWR.VOL handle clockwise.
2. Adjust loudness, further turning the PWR.VOL handle.
3. Be adjusted on the necessary station (see subsection 1.4.2, subsection 1.4.3).
4. For reception of VHF (FM) - radio stations be switched to a mode of reception of VHF (FM), choose a stereo mode - or monophonic reception.
If transfer on VHF stereo is accepted, the receiver will automatically be switched to stereo reception, at the same time on the display there will be a ST symbol. If a signal weak, be switched to a monophonic mode, having pressed the corresponding button. On the display there will be a MONO symbol.
5. Adjust a timbre and balance (see subsection 1.4.5, subsection 1.4.6).
6. To switch off the receiver, turn the PWR.VOL handle counter-clockwise.


1.3. Arrangement of identification plates

1.4.1. Using radio receiver