1.10. The combined switch of a driving and passing beam
Change of a passing beam on distant and back
Near and far light
Indexes of the right and left turns
For inclusion of lighting turn the button at the end of the lever.
First situation: only lay lighting, a tail light, illumination of registration plate and illumination of a guard of devices join.
Second situation: headlights join also.
For inclusion of a driving beam press the lever forward. For inclusion of a passing beam establish the lever in the opposite direction. For inclusion of a light signaling device the lever establish further away in the direction back.
The control lamp in a guard of devices specifies that the driving beam is included. The light signal can be included, even if the switch of a headlight is not switched on.
For inclusion of the blinking index shift switching lever up or down.
After journey on a curvilinear site the blinking light index automatically is switched in the neutral situation. However at change of a strip of the road you should return the alarm system switch to an initial position manually. About change of a strip of the road it is possible to give a signal as follows: the switch of the blinking index shift in the desirable direction only a little and then hold it with a hand.
If in a guard of devices the green bulb starts blinking quicker, than usually, it testifies that the filament lamp of a lobby or the back blinking alarm system fused. If the control lamp does not flash at all, obviously, the safety lock or a control lamp fused.